L
or block diagram is depicted in below (click on it to enlarge):
The assembly diagram with the LCD which has been used (drawing made Fritzing) is shown below (click to enlarge):
The 10k trimmer adjusts the backlight. The two pins are present if the BACKLIGHT LCD has a backlight. The RW pin is "forced" to ground (write only) so you save a connection.
The pin-out of the LCD used:
1
...
GND
2 ...
+5V
3
...
Contrasto
(va collegato sul cursore del trimmer)
4
...
RS
(collegato al pin digitale 12 di Arduino)
5 ...
RW (collegato a GND)
11,12,13,14 ...
D4,D5,D6,D7
(rispettivamente collegati ai pin digitali 5,4,3,2 di Arduino) 6 ...
ENABLE
(collegato al pin digitale 11 di Arduino) 15, 16 ... RETROILLUMINAZIONE (risp. a +5V e GND)
Per i pin fare comunque sempre riferimento al datasheet del LCD usato
0 comments:
Post a Comment