Sunday, February 7, 2010

Deep Things To Write In A Wedding Card

Installare l'IDE di Arduino su Ubuntu 9.10

Arduino 'Diecimila' e le versioni successive USB, come la '2009', usano l'arcinoto circuito integrato FT232 per realizzare Bridge USB / UART. words, so Ubuntu "sees" Arduino, you need to install on our system, a management library for this chip.
The library is installed from the command line (with the utility system
apt-get) so much easier and more convenient than with Windows ...
Let's see how to do ..

first update the package database:
$ sudo apt-get update

The package to install libftdi1
(the library for controlling hardware FTDI, compiled and written in C), then, launch :
$ sudo apt-get install libftdi1


If our system is installed the package brltty

(an access software for blind people using braille display ) this should be removed because it conflicts with the FTDI driver. Thus, to caution, however, we run the uninstall command of this package even if the result is negative:

$ sudo apt-get remove brltty brltty-x11
you are ready for testing hardware ... 's make sure that the power is derived from the 5V of USB Arduino: there is a jumper on the card, the USB plug, which must be located on the 'USB' and not 'EXT', otherwise the card is powered by an external power supply connected to its plug.
Open a shell and run:

$ tail-f / var / log / messages Arduino Connecting with the USB cable to your PC ... in the shell you should see messages like:

usb 3 - 1: new full speed USB device using ohci_hcd and address 2
usb 3-1: configuration # 1 Chosen
from 1 choice usbcore: registered new interface driver usbserial
USB Serial support registered for generic
usbcore: registered new interface driver usbserial usbserial_generic
: USB Serial Driver core
USB Serial support registered for FTDI USB Serial Device

0 comments:

Post a Comment